Sb (Stop Bits); Ap (Api Enable); Ao (Api Options) - Digi XBee3 DigiMesh 2.4 User Manual

AT commands
Parameter
0x00
0x01
0x02
Default
0

SB (Stop Bits)

Sets or displays the number of stop bits for UART communications.
Parameter range
0 - 1
Parameter
0
1
Default
0

AP (API Enable)

Set or read the API mode setting. The device can format the RF packets it receives into API frames
and sends them out the serial port.
When you enable API, you must format the serial data as API frames because Transparent operating
mode is disabled.
Parameter range
0 - 2
Parameter
0
1
2
Default
0

AO (API Options)

The API data frame output format for RF packets received.
Digi XBee3® DigiMesh RF Module User Guide
Description
No parity
Even parity
Odd parity
Configuration
One stop bit
Two stop bits
Description
API disabled (operate in Transparent mode)
API enabled
API enabled (with escaped control characters)
UART serial interfacing
58