Sb (Stop Bits); Xtend Vb Rf Modulespecial Commands; Ac (Apply Changes); Cn (Exit Command Mode) - Digi XTend vB DigiMesh XTP9B-DPM-001 User Manual

Default
3

SB (Stop Bits)

Sets or reads the number of stop bits in the data packet.
Parameter range
0 - 1
Parameter
0
1
Default
0

XTend vB RF ModuleSpecial commands

The following AT commands are special commands.

AC (Apply Changes)

Immediately applies new settings without exiting Command mode.
Parameter range
N/A
Default
N/A

CN (Exit Command mode)

Makes the device exit Command mode.
Parameter range
N/A
XTend vB DigiMesh RF Module User Guide
Configuration
1 stop bit
2 stop bits
XTend vB RF ModuleSpecial commands
57