Application Of Grease And Locktight - JUKI APW-895 Engineer's Manual

(2) Application of grease and Locktight

1. When the parts for greasing and grease sealing-in are disassembled and the operational frequency seems
to be higher than usual around these parts, grease should be replenished once every one years.
2. Recommendable grease
This sewing machine uses two types of grease as specified below. The recommendable brands of grease
are listed in (2) Parts to which grease•Locktight is applied.
A : JUKI GREASE A (IE-22)
B : JUKI GREASE B (MaruTemp SB-M)
1
JUKI Grease A •••• Used for high-speed sliding parts and their peripheral parts.
10g tube JUKI Part No.: 40006323
500g (IE-22) JUKI Part No.: 23640204
2
JUKI Grease B •••• Used, in particular, for the specific areas with highly loaded parts. Important: this
grease must be replenished at the specified intervals of period, according to "(4) Grease-up procedures
for the specified position."
10g tube JUKI Part No.: 40013640
3. Method of greasing
If no grease pump is available, fill a plastic oiler with grease. Otherwise, an injector without a needle can be
conveniently used.
4. Miscellaneous
An injector to be used exclusively for application / JUKI Part No. : GDS01007000
5. Adhesive agent
Furnish the specified places with the adhesive agents shown below.
C : Locktight 242
D : Locktight 243
E : Locktight 277
F : Locktight 641
G : Three-Bond 1373N
H : Cemedyne Super X Clear
– 152 –