Table of Contents
Advertisement
No.
Thread breakage detection
With/without thread breakage detection is selected.
Flap presser motion mode
Motion order of flap presser is selected.
* When right and left are simultaneously actuated with customizing of pedal
setting, this parameter is neglected and the right and left are simultaneously
actuated.
Clamp foot down order change-over
Lowering order of clamp foot is selected.
* When right and left are simultaneously actuated with customizing of pedal
setting, this parameter is neglected and the right and left are simultaneously
actuated.
Folding plate motion mode
"Return/No return" of folding plate when corner knife projects is selected.
Prohibition of binder reduced pressure rise
Binder reduced pressure rise [Yes/No] is set up at the time of vacant feed.
Standing pedal continuous depressing timer effective/ineffective
change-over
Effective/ineffective of
is selected.
* It i possible to set only when
Standing pedal continuous depressing timer
When performing sewing product setting work with the standing pedal
depressed, the time interval when the respective devices operate in order
is set.
* It is possible to set only when
......... Item that is not displayed due to other setting start.
Item
With thread
breakage detection
From right
Right/Left at the
same time
From right
Right/left at the same time
Return
Yes
standing pedal continuous depressing timer
one-shot pedal is set.
Ineffective
on-shot pedal is set.
Without thread
breakage detection
From left
Side where flap is
put
From left
No return
No
Effective
– 101 –
Setting range
/
Initial value
Edit unit
- - -
- - -
- - -
- - -
- - -
- - -
0.1 to 2.0
0.5 se.
/
0.1 sec.
Advertisement
Table of Contents
