Table of Contents
Advertisement
No.
Change-over of flap concealed stitching data edit reference
Making the flap concealed stitching data that is set from panel the compensation
value from the flap detecting end or the distance from detecting sensor to
sewing start is selected.
L size data range enlargement
Enlarging/not enlarging L size data range to max. 220mm + 15mm is set.
In case of
20mm + 50mm.
* When performing sewing longer that 250mm with long type clamp foot,
corner knife does not work.
Selection of sewing speed of sewing machine setting
It is selected that either memory switch or pattern data performs setting of
speed of sewing machine.
Selection of reflecting tape check mode
ON/OFF of reflecting tape check mode is set.
* When On is set, the clap foot is automatically comes lowered with the first
clamp foot advance motion after turning ON the power and deterioration
check of reflecting tape is performed.
Clamp foot is automatically lowered. Be sure to use this function only in
case of shim type.
Selection of back tuck return at sewing end compensation setting
It is selected that either memory switch of pattern data performs setting of
back tuck return at sewing end compensation.
Back tuck return at sewing end compensation
Back tuck return at sewing end compensation is set.
* It is possible to set only when
Item
Flap detecting end
compensation
long type vamp foot selection, the size is enlarged to
Not enlarging
Memory switch
OFF
Memory switch
is set to the memory switch selection.
Sensor
compensation
Enlarging
Pattern data
ON
Pattern data
– 104 –
Setting range
/
Initial value
Edit unit
- - -
- - -
- - -
- - -
- - -
- - -
-2.0 to 2.0
0.0mm
/
0.1mm
Advertisement
Table of Contents
