Adjustment Procedures
4. Installation of the air pipe and the cable
(1) Remove the air pipe stop plug
(Air pipe No. 1 )
(2) Insert the stacker cable
5. Adjustment of parallelism between wipe-out bar and sewing table
end face
(1) If no parallelism is secured from above, loosen the stacker positioning
bolt
for adjustment.
(2) If no parallelism is secured from the side, loosen the setscrew
move the stacker support plate
and insert the air pipe
in Section A.
for adjustment.
– 84 –
Results of Improper Adjustment
.
to