Moving A Block (Adding New Data To The Prior/Subsequent Data) - Mitsubishi Electric PLK-J Series Technical Manual

14. Moving a block
(Adding new data to the prior/subsequent data)
[Example] The section between the D point and E point of the following type of stitching data will be
moved to the D' point to E' point. At this time, new data will be added prior to and after the D' point
to E' point. (The D point to D' point and the E point to E' point)
Operation details
(1) Selecting block movement
►Enter the modification mode. (Refer to Page [11]-2)
►Press Stitch Data Change
and Block Move
►Press
(2) Determining the block modification range (start point)
►Using Jog
(D point)
►Press
.
(3) Determining the block modification range (end point)
►Using Jog
(E point)
►Press
.
Caution
the presser will automatically return to the start point.
Take care when the needle is lowered, etc.
→
.
to open the next screen.
determine the start point position.
determine the end point position.
When the end point is determined,
[11]‐２２