Mitsubishi Electric PLK-J Series Technical Manual page 151

(4) Setting the center position details
►If the center point is not to be set on the stitching data, use
the arrow icons and move to the position to be used as the
center.
►After setting the center, press
Note If the desired center position is on the pattern data,
do not move using the arrow,
but just press
(5) Confirming execution of conversion
►Press
.
(6) Confirming the converted data
►Quit the conversion mode.
Press to change to the saving mode screen.
It return to the standard screen after saving the data.
(When is pressed, the conversion executed last will
be undone.)
.
.
[13] ‐ １４