Pf Height - Mitsubishi Electric PLK-J Series Technical Manual

29. PF height

Operation details
(1) Selecting PF height
►Enter the modification mode.
(Refer to page [11]-2)
►Press
►Press
(2) Determining the range (start point)
►Using Jog
(A point)
►Press
(3) Determining the range (end point)
►Using Jog
(B point)
►Press
Caution
the work holder will automatically return to
the start point. Take care when the needle is
lowered, etc.
→
to switch the display and select
to open the next screen.
determine the start point position.
after determining the position.
determine the end point position.
after determining the position.
When the end point is determined,
[Example] Correct to increase PF height 1.6mm
from point A to point B on the left sewing data.
(However, the thickness of the sewn product has
already been set to 3.0mm.)
.
[11]‐５７