Step - Mitsubishi Electric PLK-J Series Technical Manual

< Continuation of [Thread trimming / Thread release ] >
Function
LLM
Setting for thread tension
release output (L) timing
LRS
Thread release output
start time/angle
LRE
Thread release output
time/angle
LP
Setting for tension release
outputs time length at
presser foot rise
LFP
Setting of thread release
output at presser foot up
in non stitch feed.
TRUD
DO NOT USE
(*1) Depending on the model, the setting range may be different.

15. Step

Function
STO
Step sequence ON/OFF
SUU
Execution number of lines
of one main loop in step
sequence.
SP1
AND priority execution
ON/OFF for step
sequence
Unit Setting range
Thread tension release output (L) timing can be set. (Please refer to timing chart for details.)
L1
L2
L3
-
L4
L5
ms/
0 to 998
deg.
ms/
0 to 998
deg.
s 0 to 10000
Sets ON/OFF of prohibition of thread tension release output at presser foot up in non stitch
feed (include JOG).
OF
-
ON
DO NOT USE
OF
-
ON
Unit Setting range
Sets ON/OFF step sequence
OF
-
ON
1 to 50
lines
Sets AND priority execution ON/OFF for step sequence
OF
-
ON
[19] - 15
Specification
Thread tension release is begun at LRS setting (degree) from
needle down position, and is ended at LRE setting (time) from
needle up position. Please refer to technical manual for details.)
Thread tension release is begun at LRS setting (degree) from
needle down position, and is ended at LRE setting (degree).
Please refer to technical manual for details.)
Thread tension release is begun at LRS setting (degree) from
needle down position, and is ended at LRE setting (time).
Please refer to technical manual for details.)
Thread tension release is begun at LRS setting (time) from
needle down position, and is ended at LRE setting (time) from
needle down position. Please refer to technical manual for
details.)
Thread tension release is begun at LRS setting (time) from
needle up position, and is ended at LRE setting (time). Please
refer to technical manual for details.)
Start time/angle of thread release output can be set. Please
refer to technical manual for details.
End time/angle of thread release output can be set.
to technical manual for details.)
Outputs tension release signal when the presser foot goes up
Thread tension release output is done at presser foot up.
Thread tension release output is not done at presser foot up.
DO NOT USE
DO NOT USE
Specification
Sets step sequence OFF
Sets step sequence ON
Sets execution number of lines of one main loop in step
sequence.
Executes in order of the input.
Executed with giving priority to AND
Please refer