Mitsubishi Electric PLK-J Series Technical Manual page 186

(5) M3 control feed setting (X, Y)
M3 control Feed setting can be changed altogether, and the feeding method can be set more finely and
easily. Changed values will be reflected in the "Feed angle" of the program mode.
However, feed motion / feed timing will be calculated automatically.
►Press
①feed motion / feed timing
►
feed motion（Minimum number of revolutions of X and Y
axes of M3 control
You can change [ M3 control feed speed ] by pressing
Mighty：Approach intermittent operation.
Mild：Approach to continuous motion.
►
feed timing (Angle from upper needle position)
You can change [ M3 control feed angle ] by pressing
Fast：The angle from the upper position of the needle is the front.
(The movement start position becomes faster.)
Late：The angle from the top position of the needle will be later.
(The movement start position is
②Feed
balance.(Arrangement of maximum rotation speed.） XUNS , YUNS
► You can change [Slope of M3
③feed speed. XUNW , YUNW
► You can change [Width of feed
As it approaches 100% it becomes intermittent feed (Deceleration becomes smaller) and as it
approaches 0% it becomes continuous feed (The motion becomes smooth).
Note：As it approaches 100%, it suddenly stops and suddenly moves, so please refrain from
operations other than low speed.
► Press the
► When you press
(The X and Y axes can be set separately)
.
feed.）
control feed
cycle ( ① )] by pressing
motion
to save the setting value.
, the X axis. Press the
①
②
delayed.)
] by pressing
to switch to the Y axis.
[17] - ３
③
.
.
initial value：1%