Mitsubishi Electric PLK-J Series Technical Manual page 224

< Continuation of [Traceability ] >
Function
S2CF
The abnormal stitch
detection 2.
S2N1
The number of ignore
stitches of the abnormal
stitch detection 2 after
sewing start
S2N2
Invalid stitches of the
abnormal stitch detection
2
S2SP
Rotation speed disregard
the abnormal stitch
detection 2
S2FL
The filter number for
sensor of the abnormal
stitch detection 2
S2N3
The number of ignore
stitches of the abnormal
stitch detection 2 before
sewing end.
S2CE
The angle for judgement
ending of abnormal stitch
detection 2.
S2TP
The timing for sewing stop
of abnormal stitch
detection 2.
Unit Setting range
Valid/invalid of stopping sewing when the abnormal stitch 2 is detected.
OF
-
ON
sti 1 to 9
sti 1 to 9
rpm 200 to 2000
time 1 to 99
sti
1 to 9
deg 0 to 359
Sets the timing for sewing stop of abnormal stitch detection 2.
NW
-
ED
[19] - 24
Specification
It do not stop sewing when the abnormal stitch 2 is detected.
It stop sewing when the abnormal stitch 2 is detected.
The number of ignore stitches of the abnormal stitch detection
2 after sewing start can be set.
The number of valid stitches which is detected by the abnormal
stitch detection sensor 2 can be set.
Rotation speed to disregard the abnormal stitch detection
sensor 2 can be set.
The filter number for the abnormal stitch detection sensor 2 can
be set.
The number of ignore stitches of the abnormal stitch detection
2 before sewing end can be set.
Sets the angle for judgement ending of abnormal stitch
detection 2.
It stop sewing immediately when the abnormal stitch 2 is
detected.
It stop after sewing end when the abnormal stitch 2 is detected.