Mitsubishi Electric PLK-J Series Technical Manual page 126

(4) Setting the M3 feed angle width and confirming execution
►Select the set value from each of the X and Y axes.
►Press
.
(5) Confirming the modifications
►Quit the modification mode. Press
saving mode screen. It return to the standard screen after
saving the data.
(When is pressed, the modifications executed last
will be undone.)
Note As a confirmation of the set value, press
(It is
The input screen of start point is displayed. (End point is the same)
The track is followed in JOG, the set value is displayed.
code default -> 0
code setting
code setting 2 ->
The above setting can be changed from the program mode "Feed angle".
to change to the
here)
1 -> 1
2
[11]‐５０
again in Modify sewing quality items mode.