Scaling - Mitsubishi Electric PLK-J Series Technical Manual

8. Scaling

[Example] The data will be reduced (X: 50%, 75%) with a fixed stitch length centering on the A' point in the
following type of stitching data.
Operation details
(1) Selecting scaling
►Enter the conversion mode.
►Press scaling
►Press
.
(2) Setting the scaling method, etc.
►Method
: No. of Stitches Fixed
: Fixed Stitch Length
(Press Fixed Stitch Length for this example.)
►Set the X, Y enlargement rate (reduction rate) with the
numeric keypad or up/down arrow icons.
►Center designation
: Jog center designation,
(Press Jog Center Designation for this example.)
►Press
.
(3) Setting the center position
►In the jog mode, move to the needle near the desired
enlargement/contraction center. (In this case, move to point
A that is near point A'.)
►Press
.
Note The center point can be designated without using
the jog icons.
In this case, press only
→
.
: Pattern center,
.
: Home position center
[13] ‐ ９