Circle Input - Mitsubishi Electric PLK-J Series Technical Manual

3. Circle input

Operation points
▪ Designate circle input
▪ Input three points (A circle, passing through the current position (already input) and two newly input points,
is created.)
Caution
created.
[Example] The following type of sewing data will be created.
Operation details
(1) Inputting feed data to A point
►Press
After making the various settings on the Data Setting Input
screen, the Arrow Input screen will open.
(Refer to page [6]-4)
►Check that the code is set to FEED. If different code is
set, press
►Press the arrow icons and move to the A point.
(Feed data to A point.)
(2) Setting feed data to A point
►The movement amount can be confirmed.
►Press
(Data on feed data to point A will be created.)
►To change the stitching type to "Circle input", press the
input method setting icon.
(In this case, the
(3) Designating circle input
►Press
►Press
►The system will return to the arrow input screen.
Note that the work holder will go back to the circle start position after the data is
and on the Standard screen.
and set the code to FEED.
to set the data.
icon.)
.
and set the data.
[7]‐８