Table of Contents
Advertisement
Mount the Controller
To reduce the risk of fire or explosion, do not install
equipment approved only for a non-hazardous
location in a hazardous location.
Location
Install the Electrostatic Controller in a non-hazardous
location only.
Mounting
The Electrostatic Controller can be mounted on the
cart or wall mounted.
Wall Mount (Flat Panel)
An optional method of mounting the controller is to
use a panel with a cutout and mounting holes.
1. See
Dimensions, page
2. Determine the mounting location. Ensure that
the location will support the mounting panel and
the controller.
3. Prepare the panel by cutting out the opening and
preparing the mounting holes for the controller:
a. If the two controller front panel screws are to
be used to attach the controller to the panel,
the panel holes will require tapping threads,
or providing some other sort of threaded
fastener, such as PEM nuts on the panel.
b. If an alternative fastener will be used, it may
be necessary to back out the two threaded
fasteners from the controller front cover so
that the mounting hardware can use the
existing controller front panel mounting holes.
3A3657C
70.
Wall Mount (Mounting Bracket)
An optional wall mount bracket (17H288) is available
to mount the controller on any flat wall.
1. See
Dimensions, page
2. Determine mounting location. Ensure that the
wall is strong enough to support the weight of the
mounting bracket and the controller.
3. Position the mounting bracket on the wall and
mark mounting holes using the plate of the
bracket as a template.
4. Drill holes and attach the mounting bracket to the
wall.
5. Attach the controller to the wall mount bracket
using two 6 mm screws (provided).
Mount the Controller
70.
15
Advertisement
Table of Contents
