Input Keys And Switches; Additional Features - Graco ProBell Electrostatic Controller Instructions And Parts

Input Keys and Switches

NOTICE
To prevent damage to the softkey buttons,
do not press the buttons with sharp objects
such as pens, plastic cards, or fingernails.
Designation Function
T1-T8 Input keys for preset values
and system parameters or
configurations. Used to
increase or decrease values
shown.
T9 Switch between system
parameters (P00–P07) and
system configurations (C0–C3)
T10-T11 Preset change.
T12 Electrostatics activate/trigger.
Switch between Run and Setup
screens.
T13 Controller power on.
T14 Controller power off.
3A3657C
Controller Display and Features

Additional Features

Keyboard Lock
The keyboard lock can be used to prevent changes
to individual voltage and current parameter values
within the Presets while the controller is operating
locally. When the keyboard lock is active, the
controller continues to allow:
• Preset selection
• Display of preset values of the current Preset
• Display of the actual values
• Error acknowledgement
Activate/deactivate the keyboard lock
1. Press the key and the
same time.
2. The display blinks when the keyboard
lock is activated.
3. The keyboard lock is cancelled by pressing the
same key combination again.
The keyboard lock status remains stored, when
switching the controller off and on. The keyboard
lock is cancelled if factory defaults are restored.
NOTE: The keyboard lock is independent from the
screen lock. The screen lock feature is present in
REMOTE operation.
Screen Lock
When in REMOTE mode, the available keypad
functions and available screens are limited because
a screen lock is active. During screen lock, the
available functions are limited to:
• Display of active preset values
• Display of the actual values
• Error acknowledgement
NOTE: If the keyboard was locked when remote
mode is entered, the
to blink.
(T8) key at the
display will continue
39