Software Update - Graco ProBell Electrostatic Controller Instructions And Parts

Repair

Software Update

NOTE: Prior to beginning a software update, make a
written copy of Preset settings that have been defined
for use with the specific materials being applied with
this system. This will ensure that the information is
recoverable in the event the software update resets
Presets to factory settings.
1. Obtain the software update files, (17J278.zip).
Unzip the file. There may be one or more files
required for the update. Put all files in the root
directory of a microSD card.
NOTE: If a microSD card is already in the main
board, this step will need to be performed after
step 4.
NOTE: There are limitations to the memory size
of the microSD card that can be supported.
Type Maximum
SD 2 GB
SDHC 32 GB
Do not use SDXC cards unless they are
formatted to FAT32 file format.
2. Switch off the Electrostatic Controller and remove
power from the system.
3. Remove four screws, then remove the controller
access cover.
4. Find the micro SD card slot on the top of the
main board, and insert the microSD card with the
software update.
5. Carefully place the controller access cover onto
the controller box. Do not screw down.
68
6. Apply power to the Electrostatic Controller and
press the on button. The screen should blink
and display donE when the reprogramming is
complete.
7. Press any button to return to normal operation.
8. Verify the software version by holding
at the same time.
9. Switch off the Electrostatic Controller and remove
power from the system.
10. If desired, remove the micro SD card from
the slot, or replace the microSD card with
another. Having a microSD card in the slot
will allow the controller to store log files. See
Setup Screen 7 (Log Level), page 47
information about logging.
11. Replace the controller access cover.
12. Screw down the front access cover.
13. Reapply power and switch on the Electrostatic
Controller.
and
for
3A3657C