Setup Screen 2 (Remote Interface) - Graco ProBell Electrostatic Controller Instructions And Parts

Setup

Setup Screen 2 (Remote Interface)

Use Setup Screen 2 (Parameter P02) to select the
remote interface (bUS) from which the controller
will accept external control. Press buttons T5/T6 to
change the setting.
The options are:
• 0 = oFF: Discrete I/O interface is disabled (local
operation).
• 1 = dio: Discrete I/O interface is enabled. This
selection is the default. See
for more information.
• 2 = CAn: CAN interface is enabled. The CAN
interface is used to communicate with Graco
modules. When CAN interface is enabled,
all inputs except Electrostatic Enable are
disabled. All outputs function normally. [See
Discrete I/O, page 20.]
NOTE: The controller must be restarted for a change
to this parameter to take effect.
44
Discrete I/O, page 20,
3A3657C