Power Supply Board Removal; Can Board Removal - Graco ProBell Electrostatic Controller Instructions And Parts

Power Supply Board Removal

1. Remove power from the system.
2. Remove four screws, then remove the back
access panel.

CAN Board Removal

1. Remove power from the system.
2. Remove four screws, then remove the controller
access cover.
3A3657C
3. Remove the two electrical connectors from the
power board, as shown.
4. Gently pry the power board from the four
retaining clips and remove the board, as shown.
3. Disconnect the CAN connection with a
screwdriver.
4. Remove nuts on the CAN connections on the
bottom of the controller.
5. Press on CAN connectors to gently remove the
CAN board.
Repair
67