Operation; System Start-Up; Presets - Graco ProBell Electrostatic Controller Instructions And Parts

Table of Contents

Operation

Press on to turn on the controller. The controller

always starts up to the last conﬁgured settings.

The controller has two sets of screens, Run and

Setup. This section includes information on the Run

screens, used to operate the electrostatic applicator.

See

Setup Screens, page

completed initial setup.

Press and hold

to toggle between the Run

screens and the Setup screens.

NOTE: When viewing Run Screens, after 5 seconds

have elapsed since the last keystroke, the display will

revert to Run Screen 1.

41, If you have not yet

The Electrostatic Controller has 251 (P000-P250)

user-deﬁned Presets. There are four values

associated with each Preset. These are:

• Voltage setpoint

• Current setpoint

• Static arc limit

• Dynamic arc limit

Voltage and current setpoints are speciﬁed on

Run Screen 1 (Electrostatic Readings), page

Arc limits are speciﬁed on

Run Screen 2 (Arc Limits), page

NOTE: Only Presets P000-P003 are accessible

through the discrete I/O interface. The CAN interface

runs in preset P000 only. All Presets (P000-P250)

are accessible in local mode.

51.

52.

3A3657C

Table of Contents