Setup Screen 11 (Transition Time) - Graco ProBell Electrostatic Controller Instructions And Parts

Setup

Setup Screen 11 (Transition Time)

• Default is 0.0 (shown)
The transition time is the time over which the
controller changes the electrostatics. The transition
time applies when electrostatics are enabled and
when the Voltage Setpoint is changed. Arc detection
remains active when the voltage setpoint is changed.
If arc detection errors occur when the voltage (or
current) setpoint is changed, increase the transition
time or adjust the Arc Detection parameters to be
less sensitive (see Arc Detection, page 54.
Use Setup Screen 11 (Configuration C3) to set
the interval of transition time (in seconds) for the
electrostatic output. This setting will help eliminate
nuisance arc detection errors during transition time.
Press T3/T4 to change the setting.
• Range is 0.0 – 5.0 sec
3A3657C 49