Conversion Of The Cpa Valve Terminal To Different Pressure Zones - Festo CPA VI Series Manual

Compact performance valve terminal pneumatics

Hide thumbs Also See for CPA VI Series:

Table of Contents

5. Maintenance and conversion

5.4.3 Conversion of the CPA valve terminal to different pressure

zones

5-20

In order to convert the CPA valve terminal to two press-

ure zones, you will require the following components:

– a sub-base with pressure zone separation

CPA10-AW-ZP or CPA14-AW-ZP

For every further pressure zone you will also require:

– a sub-base with pressure zone separation

– an additional pressure supply plate CPA10-DP-U-AW

or CPA14-DP-U-AW

In the case of CPA valve terminals with MP, CP or AS-i

connection we recommend that the conversion be car-

ried out from the right hand side. The tie rod screws are

more easily acccessible on the right hand end plate.

The method of replacing the sub-bases and fitting the

additional pressure supply plate is described under "Re-

placing the end plate, sub-base or manifold block" or

"Replacing the reserve plate or additional pressure sup-

ply plate" in this chapter.

CPA... 9808A

Table of Contents