Festo CPA VI Series Manual page 79

5. Maintenance and conversion
CPA valve terminal with MP, CP or
AS-i connection
AAAA AAA
AAAA AAA
AAAA AAA AA AA AAA
AAAA AAA AA AA AAA
AAA AAAA AA AA AAA AAA
AAA AA AA AAA
AAA
AAA
Fig. 5/4: Loosening the components on the sub-bases
CPA... 9808A
5. Loosen the fastening screws of the components on
the sub-bases by about 2 turns. In this way you will
avoid stress to the CPA valve terminal as soon as
you loosen the tie rod (see diagram).
AAAA AAA
AAAA AAA
AAAA AAA
AAAA AAA AAA AAA
AAA AAA
AAA AAA
AAA AAA
AA AA
AA AA
6. In order to replace a sub-base or a manifold
block,
remove the components on the sub-bases to be re-
placed (see this chapter "Replacing valve, reserve
or additional pressure supply plates").
CPA valve terminal with IC connection
AAAA
AAA AAAA
AAAA AAA AA AA AAA
AAAA AAA AAA AAAA AAA
AAAA AAA AAA AA AA AAA
AAAA AAA A AAA AAA AAA
AAAA AAA AA AA A A AAA
AAA AAAA AA AA AAA AAA
AAA A A AA AA AAA
AA AA AAA
AAA
AAAA
AAAA
AAAA
AAAA AAA AAA
AAA AAA
AAA AAA
AAA AAA
AAA AAA
5-11