Festo CPA VI Series Manual page 76

5. Maintenance and conversion
CPA valve terminal with MP, CP or
AS-i connection
AAAA AAAA
AAA AAAA AAAA
AAAA AAA A AAAA
AAAA AAA AAA A A AAAA
AAA AAAA AAA AAA AAAA AAA
AAA A A AAA AAA AAA
AAA AAA AAA
AAA AAA AAA
AAA AAA
Fig. 5/2: Dismantling valve plates
5-8
Loosening the components
1. Loosen the fastening screws of the relevant compo-
nents (position of fastening screws see diagram).
Use a narrow screwdriver for this purpose.
2. Remove the components from the sub-base of the
CPA valve terminal.
AAAA AAAA
AAAA AAAA
AAAA AAAA
AAAA AAAA AAA
AAAA AAAA AA AA AAA
AAA
AA AA AAA
AAA
Mounting the components
1. Check the seal for damage.
2. Replace damaged seals.
3. Make sure the seal is correctly positioned. It must lie
in the groove of the sub-base.
4. In the case of CPA valve terminals with MP, CP or
AS-i connection, carefully clip the electrical bridge
onto the new valve plate. Make sure that the plugs
of the solenoid coils do not break off.
CPA valve terminal with IC connection
AAAA AAAA
AAAA AAA AAAA
AAAA AAA AA AAAA
AAA AAAA AA AA AA AAAA
AAAA AAAA A A AAAA AAA AA AA AAAA
AAAA AAAA AAA AA AA
AAAA AAAA AAAA AAA A A AA AA
AAAA AAAA AA AAA AAAA
AAAA AAAA AA AA AAA AAAA AAA AAA A A
AAAA AAAA AAA AAAA AAA AAA
AAAA AA AA AAA AAA AAA
AAA AAA AAA
AAA AAA
AAA AAA
A
A A
A A
AAA AAAA
AAA AAAA
AAA AAAA
AAA AAAA
AAA AAAA
CPA... 9808A