Replacing The End Plate, Sub-Base Or Manifold Block - Festo CPA VI Series Manual

Compact performance valve terminal pneumatics

Hide thumbs Also See for CPA VI Series:

Table of Contents

5. Maintenance and conversion

5.3.3 Replacing the end plate, sub-base or manifold block

5-10

Dismantling

1. Loosen the

(see this chapter "Dismantling the CPA valve termi-

nal").

2. Loosen the CPA valve terminal from the mounting

surface (see this chapter "Dismantling the CPA

valve terminal").

3. Place the CPA valve terminal on a flat working sur-

face.

4. In order to replace the sub-base,

Remove the pin-type inserts from the sub-base to be

replaced. Unlock the pin-type inserts by removing

the clamping spring with a screwdriver. Pull the pin-

type inserts out of the sub-base (see diagram). Use

a screwdriver for this purpose.

Clamping spring

Pin-type inserts

Fig. 5/3: Dismantling the pin-type inserts

electrical and pneumatic connections

AAAA

CPA... 9808A

Table of Contents