Toshiba G7 Operation Manual page 79

F118
S4 Input Terminal Assignment
Program ⇒ Terminal Selection Parameters ⇒ Input Terminal
Assignment ⇒ S4
This parameter selects the functionality of the S4 input terminal.
In addition, the input terminal must be specified as Normally Open or
Normally Closed.
This parameter sets the programmable S4 terminal to 1 of the 68 possible
functions that are listed in
S5 Input Terminal Assignment
Program ⇒ Terminal Selection Parameters ⇒ Input Terminal
Assignment ⇒ S5
This parameter selects the functionality of the S5 input terminal.
Note: The S5 input terminal may be used without the ASD-Multicom
option board.
Without the ASD-Multicom option board the S5 terminal
assignment information will be stored in volatile memory. The
terminal assignment information will be lost if the system is
powered down or reset.
In addition, the input terminal must be specified as Normally Open or
Normally Closed.
This parameter sets the programmable S5 terminal to 1 of the 68 possible
functions that are listed in
S6 Input Terminal Assignment
Program ⇒ Terminal Selection Parameters ⇒ Input Terminal
Assignment ⇒ S6
This parameter selects the functionality of the S6 input terminal.
Note: The S6 input terminal may be used without the ASD-Multicom
option board.
Without the ASD-Multicom option board the S6 terminal
assignment information will be stored in volatile memory. The
terminal assignment information will be lost if the system is
powered down or reset.
In addition, the input terminal must be specified as Normally Open or
Normally Closed.
This parameter sets the programmable S6 terminal to 1 of the 68 possible
functions that are listed in
G7 ASD Operation Manual
Table 8 on pg. 76.
Table 8 on pg. 76.
Table 8 on pg. 76.
Direct Access Number — F118
Parameter Type — Selection List
Factory Default — Emergency Off
Changeable During Run — No
Direct Access Number — F119
Parameter Type — Selection List
Factory Default — Unassigned
Changeable During Run — No
Direct Access Number — F120
Parameter Type — Selection List
Factory Default — Unassigned
Changeable During Run — No
F120
73