Toshiba G7 Operation Manual page 140

F445
Regeneration Torque Limit #2
Program ⇒ Torque Setting Parameters ⇒ Manual Torque Limit
Settings
This parameter is used to set the negative torque upper limit for the #2 motor
profile when multiple motors are controlled by a single drive or when a single
motor is to be controlled by multiple profiles.
Driving Torque Limit #3
Program ⇒ Torque Setting Parameters ⇒ Manual Torque Limit
Settings
This parameter is used to set the positive torque upper limit for the #3 motor
profile when multiple motors are controlled by a single drive or when a single
motor is to be controlled by multiple profiles.
Regeneration Torque Limit #3
Program ⇒ Torque Setting Parameters ⇒ Manual Torque Limit
Settings
This parameter is used to set the negative torque upper limit for the #3 motor
profile when multiple motors are controlled by a single drive or when a single
motor is to be controlled by multiple profiles.
Driving Torque Limit #4
Program ⇒ Torque Setting Parameters ⇒ Manual Torque Limit
Settings
This parameter is used to set the positive torque upper limit for the #4 motor
profile when multiple motors are controlled by a single drive or when a single
motor is to be controlled by multiple profiles.
Regeneration Torque Limit #4
Program ⇒ Torque Setting Parameters ⇒ Manual Torque Limit
Settings
This parameter is used to set the negative torque upper limit for the #4 motor
profile when multiple motors are controlled by a single drive or when a single
motor is to be controlled by multiple profiles.
Torque Limit Mode
Program ⇒ Torque Setting Parameters ⇒ Torque Limit Settings ⇒
Torque Limit Mode
Contact Toshiba's Marketing Department for information on this parameter.
Settings:
Driving/Regen
Positive/Negative
134
Direct Access Number — F445
Parameter Type — Numerical
Factory Default — 250.0
Changeable During Run — Yes
Minimum — 0.00
Maximum — 250.0
Units — %
Direct Access Number — F446
Parameter Type — Numerical
Factory Default — 250.0
Changeable During Run — Yes
Minimum — 0.00
Maximum — 250.0
Units — %
Direct Access Number — F447
Parameter Type — Numerical
Factory Default — 250.0
Changeable During Run — Yes
Minimum — 0.00
Maximum — 250.0
Units — %
Direct Access Number — F448
Parameter Type — Numerical
Factory Default — 250.0
Changeable During Run — Yes
Minimum — 0.00
Maximum — 250.0
Units — %
Direct Access Number — F449
Parameter Type — Numerical
Factory Default — 250.0
Changeable During Run — Yes
Minimum — 0.00
Maximum — 250.0
Units — %
Direct Access Number — F450
Parameter Type — Selection List
Factory Default — Driving/Regen
Changeable During Run — No
G7 ASD Operation Manual
F450