Front View; Eoi Remote Mounting Using The Asd-Mtg-Kit - Toshiba G7 Operation Manual

EOI Remote Mounting using the ASD-MTG-KIT

Note: See Figures 30
through 6.
1. At the EOI mounting location, identify and mark the locations of the 5.00" by 4.60" hole and the
four 11/32" screw holes.
2. Cut the 5.00" by 4.60" rectangular hole.
3. Drill the four 11/32" holes.
4. Attach and secure the Bezel plate to the front side of the mounting location using the four 10-32
hex nuts, #10 split lock washers, and the #10 flat washers.
5. Attach and secure the EOI to the front side of the Bezel plate using the four 6-32 x 5/16" pan head
screws, #6 split lock washers, and the #6 flat washers.
6. Connect the RJ-45 extension cable(s).
EOI ASD-MTG-KIT Dimensions (mounting)
Figure 30. EOI Bezel Plate Mounting Dimensions.
5.00
4.25
5.38
Bezel Plate

Front View

Figure 31. Screw Length Precaution.
CAUTION: Failure to use the correct hardware may result in damage to the outer surface of the EOI panel
and/or improper seating of the panel to the bezel plate. Use caution when mounting the EOI assembly to ensure
that the internal thread clearance is maintained.
192
and 31 for the dimensions and the item locations referenced in steps
Mounting Hole
11/32" Screw Hole (4)
4.60
Correct
Side View
Incorrect
1
Bezel Plate
Back View
G7 ASD Operation Manual