Upper Deviation Limits; Lower Deviation Limits; Feedback Settings Differential (D) Gain; Pg Disconnect Detection - Toshiba G7 Operation Manual

F364

Upper Deviation Limits

Program ⇒ Feedback Parameters ⇒ Feedback Settings
This parameter determines the maximum amount that the feedback may
increase the output signal.

Lower Deviation Limits

Program ⇒ Feedback Parameters ⇒ Feedback Settings
This parameter determines the maximum amount that the feedback may
decrease the output signal.

Feedback Settings Differential (D) Gain

Program ⇒ Feedback Parameters ⇒ Feedback Settings
This parameter determines the degree that the Differential function affects the
output signal. The larger the value entered here, the more pronounced the affect
of the differential function for a given feedback signal level.
Number of PG Input Pulses
Program ⇒ Feedback Parameters ⇒ PG Settings
This parameter is used to set the end-of-travel range when using an encoder on
a motor-driven positioning system (e.g., hoist/crane, etc.).
PG Input Phases
Program ⇒ Feedback Parameters ⇒ PG Settings
This parameter determines the type of information that is supplied by the phase
encoder.
Settings:
1 — Speed
2 — Speed and Direction

PG Disconnect Detection

Program ⇒ Feedback Parameters ⇒ PG Settings
This parameter Enables/Disables the system's monitoring of the PG connection
status when using encoders with line driver outputs.
Settings:
Disabled
Enabled
122
Direct Access Number — F364
Parameter Type — Numerical
Factory Default — 50.00
Changeable During Run — Yes
Minimum — 0.00
Maximum — 50.00
Units — %
Direct Access Number — F365
Parameter Type — Numerical
Factory Default — 50.00
Changeable During Run — Yes
Minimum — 0.00
Maximum — 50.00
Units — %
Direct Access Number — F366
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Yes
Minimum — 0.0
Maximum — 2.55
Direct Access Number — F367
Parameter Type — Numerical
Factory Default — 500
Changeable During Run — No
Minimum — 1
Maximum — 9999
Units — Pulse Count
Direct Access Number — F368
Parameter Type — Selection List
Factory Default — 2
Changeable During Run — No
Minimum — 1
Maximum — 2
Units — Phase Count
Direct Access Number — F369
Parameter Type — Selection List
Factory Default — Disabled
Changeable During Run — No
G7 ASD Operation Manual
F369