Toshiba G7 Operation Manual page 221

Torque Limit Mode (Speed Dependent), 135
Torque Limit Settings, 53
Torque Proving Fault, 179
Torque Setting Parameters, 52, 53
Torque Speed Limiting, 53
Trip History, 56, 180
Trip Monitor From ASD, 181
Trip Monitor from ASD, 56, 57
Trip Record at Monitor Screen, 181
Trip Save at Power Down Enable, 154
Trip Settings, 52
Trips, 173
Trouble Shooting, 173
TTL Master Output, 169
Type Reset, 48, 62
Typeform Error, 180
U
U Phase Short Circuit, 180
UC, 175
UL 1995, 182
Undervoltage Detection Time, 159
Undervoltage Stall level, 159
Undervoltage Trip, 159
Undervoltage/Ridethrough, 52
Up Key, 36
Upper Deviation Limits, 122
Upper Limit Frequency, 40, 63
Upper Limit Frequency Adjustment, 161
Use Speed Mode, 125
User Notification Codes, 176
User Notification codes, 173
Using Vector Control, 16
Utility Parameters, 48
G7 ASD Operation Manual
V
V Phase Short Circuit, 180
V/f Adjustment, 58
V/f Adjustment Coefficient, 88
V/f Five Point Setting, 58
V/f Group, 165
V/f Pattern, 64
Vector Motor Model, 56
Vector Motor Model Autotune Command, 127
Vector Motor Model Slip Frequency Gain, 127
Versions, 48
VI, 22, 24
VI/II Bias Adjust, 135
VI/II Gain Adjust, 136
VI/II Speed Reference Setpoint #1 (%), 92
VI/II Speed Reference Setpoint #1 (frequency), 92
VI/II Speed Reference Setpoint #2 (%), 93
VI/II Speed Reference Setpoint #2 (frequency), 93
VI/II Torque Reference Setpoint #1 (%), 93
VI/II Torque Reference Setpoint #2 (%), 93
Viewing Trip Information, 180
Voltage and Frequency Rating of the Motor, 40
Voltage Compensation Coefficient for Dead Time, 139
Voltage Vector Control, 138
Volts per Hertz Setting, 41
W
W Phase Short Circuit, 180
Warranty Card, 3
Wizard Finish, 42
215