G7 Optional Devices - Toshiba G7 Operation Manual

G7 Optional Devices

The ASD may be equipped with several options which are used to expand the functionality of the ASD.
Table 22 lists the available options and their functions.
Item
ASD7-SIM2
ASD-BPC
ASD-CAB-PC
ASD-EOI-N4
ASD-ISO-1
ASD-MTG-KIT
ASD-RTC
ASD-SS
ASD-TB1-AC1
Conduit
Extender Box
(option)
HS35 Encoder
Note: Multicom boards are identified as ASD-Multicom-A, -B, -F, etc.
-A
-B
-F
-J
-S
-X
Note: See the user manual of the applicable option for further information on each item.
200
Table 22. G7 Optional devices and functions.
Emulates the input control signals of the G7 ASD via switches and pots.
Provides dust protection for the G7 ASD when the EOI is removed or mounted remotely.
Female 9-pin d-type to RJ-45 (PC to ASD cable).
A replacement NEMA-4 EOI (without Rotary Encoder)
Provides isolation of the Control Board output circuit from the AM/FM output and
from the II input.
EOI Remote Mounting Kit. See the section titled
further information on this option.
The Real Time Clock provides the user with a time stamp of the Start, Run, and Fault
events.
This option board is used to provide a hardware-based speed search function.
Note: The ASD-SS is a factory-authorized service center-installed option for
all 1 – 5 HP ASDs, 10 – 25 HP 230 volt ASDs, and 15 – 40 HP 460
volt ASDs (see F314).
Note: On ASDs that are rated at 50 HP and above, the ASD-SS hardware
option cannot be used if using a shaft-mounted encoder.
Provides 120 VAC discrete terminal activation and additional I/O terminals.
Provides more working space for conduit installation than the standard conduit plate.
Provides rotational speed and/or directional information. The Encoder is mounted on the
motor shaft or the shaft-driven equipment.
Note: On ASDs that are rated at 50 HP and above, the ASD-SS (Speed
Search) hardware option board cannot be used if using a shaft-
mounted encoder.
Incorporates the Modbus, Profibus, or Device Net communications protocol for system
control and is able to receive and process Vector Control feedback.
Provides a line driver and open collector interface for system control.
The Tosline-F10 interface provides high-speed communication to Toshiba control
equipment via twisted pair wiring.
Able to receive and process vector control feedback via line driver or open collector
interface.
The Tosline-S20 interface provides high-speed communication to Toshiba control
equipment via fiber optics.
Provides extended terminal I/O functions for monitoring, feedback, and control.
Device Function
EOI Remote Mounting on pg. 190
ASD – Multicom Option Boards
for
G7 ASD Operation Manual