Toshiba G7 Operation Manual page 67

The magnitude of the AM/FM output signal at full-scale is selection-specific and may be
adjusted (see
F671
full-scale output setting of the AM/FM terminal for each selection. The column on the right side
of shows the actual AM/FM output for an EOI display of 100% (default setting).
Table 7
Table 7. Output terminal selections for the AM, FM, FP, and Analog 1&2 terminals.
Function
Output Frequency (FM and FP default setting)
Frequency Reference
Output Current (AM default setting)
DC Bus Voltage
Analog 1 default setting)
Output Voltage (
Post-compensation Frequency (
Speed Feedback (realtime)
Speed Feedback (1 sec filter)
Torque
Torque Command
Internal Torque Base
Torque Current
Excitation Current
PID Feedback Value
Motor Overload Ratio
ASD Overload Ratio
PBR (DBR) Overload Ratio
PBR (DBR) Load Ratio
Input Power
Output Power
Peak Output Current
Peak DC Bus Voltage
PG Counter
Position Pulse
RR Input
VI/II Input
RX Input
RX2 Input
FM Output (used for factory testing only)
AM Output (used for factory testing only)
Meter Adjust Value
Analog Output
Load Torque
G7 ASD Operation Manual
and ) to fit application-specific requirements.
F006
Analog 2 default setting)
Table 7
AM/FM Output Value at
100% EOI-Displayed Output
Maximum Frequency
150%
Maximum Frequency
150%
Maximum Frequency
Motor Overload Trip Point Setting
ASD Overload Trip Point Setting
DBR Overload Trip Point Setting
Maximum DBR Duty Cycle
1.73 * input voltage * ASD rated current
150%
32767 Encoder Pulses
100%
150%
shows the default
61