Configuring The Pna Software For A Self Configured System; Configuring Non-Lfe Broadband And Lfe And Non-Lfe Banded Systems - Keysight PNA Series Operation And Installation Manual

System Installation

Configuring the PNA Software for a Self Configured System

Configuring the PNA Software for a Self Configured System
Configuring Non-LFE Broadband and LFE and Non-LFE Banded
Systems
1. On the PNA, select: Utility > System > Configure > Millimeter Module
Figure 3-14 Millimeter Module Configuration Dialog Box
2. On the dialog box, under Available Configuration(s), select New.
3. Enter a name for your system (e.g., Non-LFE Broadband System 10 MHz to
4. Select the appropriate test set (e.g., N5292A).
5. Select the check-box Enable Test Set RF ALC.
6. Click OK. This activates the millimeter-wave mode for the PNA.
Keysight Self-Configured System Installation Guide
Configuration. The dialog box shown in the following figure will be
displayed.
110 GHz).
— Broadband systems: This completes the setup.
3-19