Oml/Vdi Millimeter-Wave Module Cable Connections - Keysight PNA Series Operation And Installation Manual

System Installation
PNA, Controller, and Test Head Module Interconnections
Test Head Connections
— N5293A/5A Test Head Modules:
1. Select a test head module to connect to the N5292A's integrated
2. Connect to the N5292A using the integrated connector.
— N5290A304 (for OML/VDI) Heads:
Select a test head module to connect to the N5292A's integrated ports. The
test head modules are independent and can connect to any port on the
N5292A. Connect one end of the N5290A504 cable to the OML/VDI head.
Refer to
page

OML/VDI Millimeter-wave Module Cable Connections

Before connecting the millimeter-wave modules, verify that the test set and the
power supplies (if used) are powered down. See also,
and Figure 3-13 on page
There are four RF cables for each T/R module. Cables provided with the VDI
modules are pre-labeled. The cables for use with the OML modules come in
two types, two lighter and two heavier. Use the lighter cables for the IF signals
and the heavier cables for the RF and LO signals.
Connecting the OML/VDI mm-heads to the N5292A test set requires a
N5290A304 cable adapter. One cable adapter is required for each OML/VDI
mm-wave head.
The N5290A304 cable is 1.2 m long. If longer cables are required, an
N5260AKCBL cable kit and four 3.5mm f-f adapters can be added as a
cable extension for the N5290A304. When using OML/VDI heads with an
N5260AKCBL cable kit and four 3.5mm f-f adapters as the cable extension
of the N5290A304, it is important that the minimum power level required is
met for each head. Refer to the OML/VDI specifications on:
https://www.omlinc.com/
—
and
https://www.vadiodes.com/.
—
3- 16
ports. The test head modules are independent and can connect to
any port on the N5292A.
"OML/VDI Millimeter-wave Module Cable Connections" on
3-16.
18.
Keysight Self-Configured System Installation Guide
Figure 3-12 on page 17