Running The Installation Calibration (Broadband Systems Only) - Keysight PNA Series Operation And Installation Manual
2-port and 4-port microwave network analyzer system
Hide thumbs
Also See for PNA Series:
- Configuration manual (47 pages) ,
- Selection manual (82 pages) ,
- Installation and service manual (72 pages)
Table of Contents
Advertisement
System Installation
Running the Installation Calibration (Broadband Systems Only)
Running the Installation Calibration (Broadband Systems Only)
This installation calibration should be ran when you first install your
broadband system and whenever you make any changes to your system's
configuration. See also
Modules" on page
1. On the PNA, verify your Millimeter-wave system is in the correct
2. The Millimeter Configuration window that opens should have the name of
3- 30
3-33.
configuration: Press Setup > External Hardware > Millimeter Config.
your broadband system highlighted.
Else, press your broadband system.
"Troubleshooting the OML/VDI MiIlimeter
Keysight Self-Configured System Installation Guide
Hide quick links:
Advertisement
Table of Contents
