System Installation - Keysight PNA Series Operation And Installation Manual

Keysight N5290/1A PNA/PNA-X Series
2-Port and 4-Port Microwave Network Analyzer System
Installation Guide
3

System Installation

IMPORTANT!
A 85059B 1.0 mm Precision Calibration Kit and a 85059V 1.0 mm Precision
Verification Kit are required to complete the installation of the N5290/1A
Millimeter-wave Systems.
This document is applicable to non-LFE broadband millimeter-wave
systems and non-LFE and LFE banded millimeter-wave systems. Where
the text applies to both types of systems, "millimeter-wave system" is
used. Where the content is specific to one or the other types of systems,
"non-LFE broadband millimeter-wave system" or "banded
millimeter-wave system" is used.
For N5290/91A LFE broadband millimeter-wave system information refer
to https://literature.cdn.keysight.com/litweb/pdf/N5292-90002.pdf.
IMPORTANT! For additional information on the OML/VDL heads, refer to
"OML/VDI and N5293A/5A Test Heads – Banded Configuration Calibration
(Only)" on page 3-21.
3-1