Rear Panel Features - Keysight PNA Series Operation And Installation Manual

System Description
N5292A Test Set Description

Rear Panel Features

Figure 2-7 N5292A Option 200 (2-Port) and 400 (4-Port) – Rear Panel Features
IF OUTPUTS – SMA (female)
— D (from the test set to the analyzer's IF D Input)
— C (from the test set to the analyzer's IF C Input)
— R (from the test set to the analyzer's IF R Input)
— A (from the test set to the analyzer's IF A Input)
— B (from the test set to the analyzer's IF B Input)
LO IN
This input is from the LO drive of the analyzer. The signal is split and amplified
and then output to the front panel of the N5292A Option 200/400.
Test Set I/O
The test set interface connector is used digitally control to the test set from the
analyzer.
Line Module
This assembly houses the line cord connection. Line voltage selection is
automatic and no setting is required.
Power Cords
A line power cord is supplied in one of several configurations, depending on
the destination of the original shipment. Keysight can supply additional
certified power cords to meet region electrical supply and receptacle
configurations. Please refer to our website at: www.keysight.com for
assistance in power cord selection.
Keysight Self-Configured System Installation Guide 2-13