Getting Prepared; Tools Required For The Installation; About Installing The System - Keysight PNA Series Operation And Installation Manual

System Installation

Getting Prepared

Getting Prepared
The banded and broadband N52xxB, N5292A test set, and modules
contain extremely sensitive components that can be ruined if mishandled.
Follow instructions carefully when making cable connections, especially
wire harness connections.
The person performing the work accepts responsibility for the full cost of
the repair or replacement of damaged components.
To successfully install this banded network analyzer system, you will need the
following:
— Sufficient AC power – refer to
— Correct tools – refer to
— Enough time - refer to

Tools Required for the Installation

Description
T-10 TORX driver (set to 9 in-lbs)
T-20 TORX driver (set to 21 in-lbs)
5/16-in torque wrench (set to 8 in-lbs)
5/16-in torque wrench (set to 10 in-lbs)
5/16-in torque wrench (set to 21 in-lbs)
14 mm open-end wrench (set to 4 in-lbs)
20 mm open-end wrench (set to 8 in-lbs)
Use a 5/16-in torque wrench set to 8 in-lbs on all semirigid front and rear
panel cable connections.

About Installing the System

Products affected
Installation to be performed by
Estimated installation time
Estimated full instrument verification time
Keysight Self-Configured System Installation Guide
"Site Preparation" on page 1-13
"Tools Required for the Installation" on page
"About Installing the System" on page
N52xxB, N5292A, N5293A/95A (broadband), and OML/VDI
(banded).
Keysight customer engineer or personnel qualified by Keysight
4 hours
2.0 hours
3-3.
3-3.
Qty Part Number
1 N/A
1 N/A
1 N/A
1 N/A
1 N/A
1 N/A
1 N/A
3-3