Setting Up A Table-Top Unit On A Work Surface (Standard Model) - Convotherm 4 Series Installation Manual

5 Setting up the appliance
5.6 Setting up a table-top unit on a work surface (standard model)
Rules for setting up the appliance safely
Observe the following rules to ensure that the appliance is installed in a stable situation:
It must be possible to set up the worktable in the installation position so that it cannot tip over or
■
slide about. The supporting surface must comply with requirements.
The appliance must be installed on the worktable worktop so that it cannot tip over or slide about.
■
If you intend to load the combi oven using mobile shelf racks or plate racks (does not apply to
■
ConvoSmoke), the appliance must be installed at the same height as the loading height of the
transport trolley. The roll-in frame inserted in the cooking chamber and the surface on which the
mobile shelf rack / plate rack sits on the transport trolley must be at the same height when the
transport trolley is attached to the combi oven.
It must be possible to wheel the transport trolley up to the cooking chamber and to fix it to the roll-in
frame on a horizontal surface that is clear of obstructions.
Setting up the appliance on a worktable
1.
2.
Position the appliance on the worktable.
Remove the cover from the appliance foot.
60