Convotherm 4 Series Installation Manual page 54

5 Setting up the appliance
4.
5.
Unpacking the appliance (floor-standing units)
1.
2.
Remove all the corner pieces one at a time by lifting up
■
the top cover briefly at each corner.
Then take the top cover off completely.
■
Remove the customer documentation from the top of the
■
appliance.
Remove any additional protective films, cardboard pack‐
■
aging or transport securing devices etc. completely from
the appliance.
Inspect the appliance again for damage.
If you suspect the appliance has been damaged during
transit, notify your dealer/carrier immediately. Please notify
the manufacturer in writing within three days.
Never install or put into service a damaged appliance un‐
der any circumstances.
Inspect the appliance for damage before signing the deliv‐
ery note. Record any damage on the delivery note and no‐
tify the carrier and manufacturer.
Use a cutting tool to cut open the stretch plastic cover from
top to bottom along one of the corner pieces.
54