Convotherm 4 Series Installation Manual page 105

6 Installation
For floor-standing units or table-top units on a work surface:
The box can alternatively be screwed to a wall using the holes in the rear wall of the box. The
■
mounting brackets must be removed from the box first before wall-mounting. It is best to fit the box
at a nominal distance above the floor to make it easier to clean the kitchen floor. When you fit the
box, follow the requirements in 'Installation location for the cleaning agent and rinse aid canisters'.
Installation location for the cleaning-agent and rinse aid canisters
Install the canisters as follows:
The canisters should be located for easy access beside the appliance on a flat surface.
■
The surface on which the canister sits must not lie above the level at which the appliance feet meet
■
the appliance case.
The surface on which the canister sits must not lie more than 1 metre below this level.
■
105