Convotherm 4 Series Installation Manual page 55

5 Setting up the appliance
3.
4.
5.
6.
Cut the fastener holding the stretch plastic.
Remove all the corner pieces one at a time by lifting up
■
the top cover briefly at each corner.
Then take the top cover off completely.
■
Remove the customer documentation from the top of the
■
appliance.
Remove any additional protective films, cardboard pack‐
■
aging or transport securing devices etc. completely from
the appliance.
Read first:
This step 5 is not needed for the floor-standing marine
■
model.
Undo the screw fastenings on the slides and pull the slides
out. Keep the screws and slides to hand.
Additional information:
The slides will be used as a ramp for the appliance.
■
Inspect the appliance again for damage.
If you suspect the appliance has been damaged during
transit, notify your dealer/carrier immediately. Please notify
the manufacturer in writing within three days.
Never install or put into service a damaged appliance un‐
der any circumstances.
55