Table of Contents
Advertisement
5. The following entries have to appear in the center window of the dialog:
Note
Prerequisite for the access to the controller is that the operating mode switch
of the controller is in the center or top position.
6. Under "Online" click on the "Log-on" menu point to log into the
7. If there is not a program contained in the controller, a window appears
8. As soon as the program is loaded, you can start processing the program via
9. To terminate the online operation, return via the "Online" menu and click
WAGO-I/O-SYSTEM 750
Bus System
- Interface
Number of the Interface corresponding to PC configuration
Class 2 station address of the master
- Baud rate
Baud rate of the PROFIBUS system
- Node number
Station address of the PROFIBUS controller to be programmed
- Highest station address
Highest station address in the PROFIBUS network
- Waiting time
Waiting time in ms for the preparation of the station list
- Data base
To operate the PROFIBUS card (WAGO) as a class 2 master, the data base
on the card must be deleted only once by WAGO-I/O-PRO. Once the data
base has been deleted, it can be left unchanged.
controller.
(During online operation, the WAGO-I/O-PRO server is active. The
communication parameters cannot be polled.)
asking whether or not the program is to be loaded. Confirm with "Yes".
Subsequently the current program is loaded.
the "Online" menu, menu point "Start".
At the right-hand end of the status bar, the system signals "ONLINE
RUNNING".
on the "Log-off" menu point.
Programmable Field Bus Controller 750-833
Programming of the PFC with WAGO-I/O-PRO
• 75
Advertisement
Table of Contents
