WAGO I/O SYSTEM 750 750-833 Manual page 72

72 • Programmable Field Bus Controller 750-833
Programming of the PFC with WAGO-I/O-PRO
1. Start the WAGO-I/O-PRO software via 'Start/Programs' or by double
2. In the "Online" menu click on the "Communication parameters" menu
3. In the selection window mark the desired driver on the right-hand dialog
4. In the center window of the dialog, the following entries have to appear:
Note
To be able to access the controller, ensure that the operating mode switch of
the controller is set to the center or the top position.
5. Under "Online" click on the "Log-on" menu point to log into the controller.
6. If there is not a program in the controller, a window appears asking whether
7. As soon as the program is loaded, you can start the program via the
8. To terminate the online operation, return via the "Online" menu and click
clicking on the WAGO-I/O-PRO symbol on your desk top.
point. The dialog "Communication parameters" opens.
side (i.e. "Serial (RS232)", to configure the serial connection between PC
and the controller).
-Parity: Even
-Stop bits: 1
If necessary, change the entries accordingly.
You can now commence testing the controller.
(The WAGO-I/O-PRO Server is active during online operation. The
communication parameters cannot be polled.)
or not the program is to be loaded. Confirm with "Yes". Subsequently the
current program will be loaded.
"Online" menu, menu point "Start". At the right-hand end of the status bar,
the system signals "ONLINE RUNNING".
on the "Log-off" menu point.
WAGO-I/O-SYSTEM 750
Bus System