Conforming Use Of Series 750; Technical Condition Of The Devices - WAGO I/O SYSTEM 750 750-833 Manual

10 • Important Notes
Legal Principles
All personnel must be familiar with the applicable standards.
WAGO Kontakttechnik GmbH & Co. KG declines any liability resulting from
improper action and damage to WAGO products and third party products due to
non-observance of the information contained in this manual.

1.1.3 Conforming Use of Series 750

The couplers and controllers of the modular I/O System 750 receive digital
and analog signals from the I/O modules and sensors and transmit them to the
actuators or higher level control systems. Using the WAGO controllers, the
signals can also be (pre-)processed.
The device is designed for IP20 protection class. It is protected against finger
touch and solid impurities up to 12.5mm diameter, but not against water
penetration. Unless otherwise specified, the device must not be operated in
wet and dusty environments.

1.1.4 Technical Condition of the Devices

For each individual application, the components are supplied from the factory
with a dedicated hardware and software configuration. Changes in hardware,
software and firmware are only admitted within the framework of the
possibilities documented in the manuals. All changes to the hardware or
software and the non-conforming use of the components entail the exclusion
of liability on the part of WAGO Kontakttechnik GmbH & Co. KG.
Please direct any requirements pertaining to a modified and/or new hardware
or software configuration directly to WAGO Kontakttechnik GmbH & Co.
KG.
WAGO-I/O-SYSTEM 750
Bus System