Table of Contents
Advertisement
SECTION 4 - EMERGENCY PROCEDURES
Platform - Manual Descent Tool Operation
(See Figure 4-1.)
If the battery should run out of charge before the platform has
fully descended:
1. Remove the cordless drill and hexagonal drive bit at
the top of the mast and place it elsewhere in the plat-
form or tool tray.
If the optional powerpack is installed, remove it and
place it elsewhere in the platform or tool tray.
2. Remove the manual descent crank (1) from the
mounting clips inside the platform.
3. Engage the hexagon drive bit on the end of the man-
ual descent crank with the hexagon drive gear port at
the top of the mast (2).
4. Push down on top of the handle to engage the drive
gear and turn the crank counter-clockwise until the
platform is fully lowered.
NOTE: FT140 machine, if both masts are extended, you will only
be able to reach the upper (FT70) mast first, once that is
fully lowered move the manual descent tool to the (FT140)
mast and lower it until mast is fully retracted before exit-
ing platform.
4-2
Figure 4-1. Platform - Manual Descent Tool Operation
LIFTPOD by JLG
2
1
3121296
Advertisement
Table of Contents
