Mast To Base/Mount Installation (Ft140) - JLG LiftPod FT70 Operation, Safety, Service And Maintenance Manual

1
2
Figure 3-9. Mast to Base/Mount Installation (FT140)
1. FT140 Mast Assembly
2. FT140 Base Mast Mount (Stump)
3121296
3
4
3. FT70 Mast Assembly
4. FT70 Mast Mount (Stump)
5. Attach the platform to the mast (See Figure 3-10. and
Figure 3-11.).
a. Lift up on the platform latch handle and hold
open.
b. Lift the platform onto the mast, be certain the
platform's mounting pins are aligned with the
holes in the mast pin mounts, and the platform
lower mount is properly engaged over the lower
mount bracket, then slowly lower platform down
to seat properly.
c. Release the platform latch handle until it is fully
engaged under the pin mount.
CHECK: Try to lift the platform out, if it does
not release, then the platform has engaged
properly. (See Figure 3-10.)
NOTE: When reversing the procedure to disassemble the
machine, lift up on the platform latch handle to release it
and lift the platform from the mast.
LIFTPOD by JLG
SECTION 3 - MACHINE OPERATION
3-9