JLG LiftPod FT70 Operation, Safety, Service And Maintenance Manual page 102

6. Thread the nut back on the driven gear screw and
tighten to secure the driven gear to the top of the
drive screw.
7. Carefully reassemble the upper half of the gearbox
housing back onto the lower half of the gearbox hous-
ing. Assemble evenly at both ends to avoid cracking or
breaking the housing.
8. Use the (6) screws and nuts to secure the upper hous-
ing to the lower housing.
3121296
SECTION 6 - SERVICE/MAINTENANCE AND REPLACEMENT PARTS
Reassemble the mast assembly reversing the above proce-
dures.
Reassemble the mast with the drive screws extended.
Use Figure 6-2. on page 6-10 for slide pad positioning when reas-
sembling the mast sections. Set slide pad adjustment screws
tight enough to remove any mast section movement side to
side and fore and aft. Do not overtighten slide pad adjustment
screws, this will bind the mast thereby reducing the number of
up/down cycles when using the optional power-pack or porta-
ble drill.
Check the nylon gas strut guides, where the gas struts pass
though the gear box (item 5 - Figure 6-1. on page 6-9) and the
drive screw attach bracket (item 8 - Figure 6-1. on page 6-9) for
excessive wear or breakage. Replace if necessary.
Use the gas strut removal tool to compress and reattach the gas
strut mounts and align the mount holes with the mast holes.
Secure mounts with the allen head socket screws.
LIFTPOD by JLG 6-17