Latch Release Handles (1 Each Side); Control Unit/Drive Unit Driveshaft; Latch Locking Tabs; Lithium-Ion Battery - JLG LiftPod FT70 Operation, Safety, Service And Maintenance Manual

SECTION 3 - MACHINE OPERATION
• FLASHING RED indicates (platform down operation
only)
• RED indicates (power pack needs serviced or wrong
operation)

Latch Release Handles (1 each side)

(Item 7 - Figure 3-20.)
These handles are used when attaching or removing the Con-
trol/Drive Units from the machine. Press both latches on each
side when attaching or removing. When the unit is seated on
top of the mast, the latch tabs on the bottom of the power pack
engage slots in the mast cap.

Control Unit/Drive Unit Driveshaft

(Item 8 - Figure 3-20.)
This hexagonal steel shaft on the bottom of the unit is inserted
into the drive gear receptacle in the mast cap. When the drive
motor is energized, the driveshaft turns the gear mechanism to
extend or retract the mast sections.

Latch Locking Tabs

(Item 9 - Figure 3-20.)
When properly installed these tabs engage the notches in the
mast cap guides to secure the unit to the top of the mast during
operation. They are retracted when the latch release handles are
depressed for removal of the power pack.
3-24

Lithium-Ion Battery

(Item 10 - Figure 3-20.)
This removable battery provides the energy for both the Control
Unit and Drive Unit drive motors to raise and lower the platform.

Connection Port for FT140 Drive Unit

(Item 11 - Figure 3-20.)
This port is for connection of the Control Unit
and the Drive Unit through supplied electrical
cable. When the Mast Select Button is set to
FT140, control and battery power is provided
through this cable to the FT140 drive unit.
DISCONTINUE USE OF THE POWERPACK IF A FAULT IS DETECTED.
DO NOT PRESSURE-WASH THE POWERPACK OR DRIVE UNIT.
LIFTPOD by JLG
NOTICE
3121296